4.3 Disconnecting the server from the mains
Figure 2: Unlocking the cable clamp of a power supply unit
Ê Press the cable clamp down until it disengages (1).
Ê Open the cable clamp (2).
Ê Disconnect the power cord from the power supply unit and remove it from
cable clamp.
4.4 Getting access to the component
V CAUTION!
●
Only for non-hot plug components:
Before removing or attaching covers, turn off the server, all peripheral
devices, and any other connected devices. Also unplug all power
cords from the outlet. Failure to do so can cause electric shock.
●
The top cover must be replaced as soon as possible for purposes of
cooling, to comply with EMC regulations (regulations regarding
electromagnetic compatibility) and to prevent fires.
●
For further safety information, please refer to chapter "Important
information" on page 33.
/
0
To Next Page
Loading...
