Ê Remove the corresponding riser module as described in section "Removing
a riser module" on page 62.
Figure 216: Removing the serial interface - example riser module 1
Ê Remove the serial interface.
14.2.3 Installing the slot cover
Ê Install the corresponding slot cover as described in section "Installing the
slot cover (only slot 2-4)" on page 194.
Ê Install the corresponding riser module as described in section "Installing a
riser module" on page 63.
14.2.4 Concluding steps
Ê "Reassembling" on page 54
Ê "Connecting the server to the mains" on page 60
Ê "Switching on the server" on page 61
Ê "Resuming BitLocker functionality" on page 95
To Next Page
Loading...
