7.3.4.2 Removing the defective 3.5-inch HDD module
Ê Remove the HDD module as described in section "Removing a 3.5-inch
HDD module" on page 149.
7.3.4.3 Installing the new 3.5-inch HDD module
Ê Install the HDD module as described in section "Installing a 3.5-inch HDD
module" on page 147.
7.3.4.4 Concluding steps
Ê "Performing a RAID array rebuild" on page 96
7.3.5 Replacing the 3.5-inch HDD backplane
7.3.5.1 Preliminary steps
Ê "Locating the defective server" on page 45
Ê "Shutting down the server" on page 48
Ê "Disconnecting the server from the mains" on page 49
Ê "Getting access to the component" on page 49
Ê Release all HDD modules and pull them out a few centimeters, see section
"Removing a 3.5-inch HDD module" on page 149
I The HDD modules need not to be removed completely. But if you
want to remove them nevertheless, check if all HDD modules are
uniquely identified so that you can reinsert them into their original
bays.
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools: tool-less
To Next Page
Loading...
Need help?
General