15.7.1.4 Concluding steps
Ê "Installing the iRMC microSD card" on page 323 (if applicable)
Ê "Installing the SATA DOM" on page 319 (if applicable)
Ê "Installing the TPM" on page 309 (if applicable)
Ê "Installing the UFM" on page 300 (if applicable)
Ê Install the memory modules, see section "Installing a memory module" on
page 233.
I Make sure that you reinstall each memory module in the slot it was
located before the replacement.
Ê Install all fans, see section "Installing the new fan module" on page 159.
Ê Install the heat sink, see section "Installing the heat sink" on page 257.
Ê Install the DynamicLoM module (if applicable), see section "DynamicLoM
modules" on page 179.
Ê Install all expansion cards, see section "Expansion cards and riser cards" on
page 189.
I Make sure that you reinstall each card in the slots it was located
before the replacement.
Ê Install all power supply units, see section "Installing a power supply unit" on
page 107.
Ê "Reassembling" on page 54
Ê "Connecting the server to the mains" on page 60
Ê Connect all external cables.
Ê "Updating or recovering the system board BIOS and iRMC" on page 79
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
Ê "Verifying system information backup / restore" on page 81
Ê If customer BIOS settings are not restored automatically, please change the
settings manually (using the information collected during "preliminary
steps"). If you couldn't determine the BIOS version, ask the customer to
reconfigure all BIOS settings and password.
To Next Page
Loading...
Need help?
General