Ê Press the [Y] key to exit the Utility menu.
Ê Start BIOS Configuration Utility
– Press the [F2] key during POST phase.
– Select Advanced Menu.
– Select Onboard Devices Configuration
Onboard CNA Enabled
Onboard CNA Oprom Enabled
– In the Save & Exit menu select the required parameter and press the
[Enter] key
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
Ê Configuration of network settings should be performed by the customer.
To Next Page
Loading...
Need help?
General