General Measurements and Calculations
7-12 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Specifying measurement and display options (continued)
Trace Auto/Manual To select Auto Doppler Trace or Manual Doppler Trace, select
the Options tab, then select Trace. Toggle between Auto and
Manual Doppler Trace by pressing the Touch Panel control.
• Select AUTO – the system traces the Doppler waveform
from the begin time to the end time.
• Select MANUAL – trace the waveform manually.
Show Caliper Line While you are making a measurement, the system displays a
dotted line to show the measurement. After you press Set to
complete the measurement, the dotted line remains on the
display if the Show Caliper Line in the Options tab is selected. If
Show Caliper Line is not selected, the system erases the dotted
line and only the measurement calipers with a number or symbol
are displayed. The Show Caliper Line on the Options tab takes
precedence over the Cursor Line Display preset, found on the
System -> System Measure screen.
To Next Page
Loading...
Need help?
General
