GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 3 - System Setup 3 - 65
3-9-14-6 DICOM Storage Properties Adjustments
IP-address
1.) Select the down-arrow at the IP-Address pull-down menu to select the DICOM Storage server.
2.) Select <modify> from the pull-down menu if you need to modify the server’s parameters or add a
new server. This will bring up the IPs dialog.
If no changes are needed, continue with step 7.
3.) To modify any of the settings, select the server you want to modify, and then select Modify. This
will bring up the Enter name and Ip dialog.
4.) In the Enter name and Ip dialog you can modify the server’s name and IP-address.
-Select OK to save the new settings and close the dialog.
- Select Cancel to close the dialog without saving the changes.
5.) If you want to add a new server, select Add in the IPs dialog.
a.) Type the server’s name and IP-address in the Enter name and Ip dialog.
b.) Select OK to save the new settings and close the dialog. Cancel will close the dialog without
saving the changes.
6.) Follow these steps if you want to delete any of the servers from the list:
a.) Select the server you want to delete, and then select Delete. This will bring up a warning where
you are asked if you want to delete the server from the list.
b.) Select OK to confirm or Cancel if you don’t want to delete the server.
Figure 3-65 IP Adjustments
Figure 3-66 The IPs dialog
To Next Page
Loading...
