GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
3 - 66 Section 3-9 - Connectivity Setup - Software v7.x (BT’08), v6.x, v5.x and v4.x
3-9-14-6 DICOM Storage Properties Adjustments (cont’d)
7.) Next, verify the other settings and parameters as described below.
Name
Raw data Storage - Name of service.
AE Title
DICOMSTORAGESCP - The DICOM server’s AE Title.
Port No
Verify / set the DICOM server’s Port Number.
Image Settings
• Allow Raw Data - default ON (checked)
• Raw Compr. - default OFF (unchecked)
• Allow Multiframe - default ON (checked)
• Only Black and White - default OFF (unchecked)
• Max Framerate - The pull-down menu gives you these choices;
- 25 - 25 pictures per second
- 30 - 30 pictures per second
- Full - the scanning frame rate
• Compression - The pull-down menu gives you these choices;
- Jpeg - Jpeg - JPEG/JPG compression (Default). JPEG is not lossless.
- None - (un-compressed data with huge files)
- Rle - Run Length Encoding. This is lossless compression.
• Quality % - Set the wanted quality %. Default value is 95%.
- If files are stored with a quality lower than 95% they will occupy less space, but loose some
quality.
- If files are stored with a quality above 95% thee files will grow much bigger without almost no
quality change.
To Next Page
Loading...
