GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
4 - 6 Section 4-2 - General Procedures
4-2-2-2 Turn Unit On (cont’d)
f.) A start-up bar indicating the time used for software loading, is displayed on the monitor.
g.) The software initiates and sets up the Front-End electronics and the rest of the instrument.
h.) The backlight in the keyboard is lit.
i.) As soon as the software has been loaded, a 2D screen is displayed on the screen.
NOTE: Total time used for start-up is typical three minutes or less, depending on software version and
Vivid 7 model.
Figure 4-5 Start-up bar
Figure 4-6 2D Screen on the display.
The Start-Up Screen (Splash Screen) Is different, depending on software version and Vivid 7 model. Vivid 7 Dimension with software version v6.1 or
higher (upper, left), Vivid 7 Dimension with software version v4.0 to v6.1.x, (middle) and Vivid 7 with software versions v3.x.x and lower (lower, right).
2D SCREEN ON
UNITS WITH
SOFTWARE VERSION
v4.x, v5x, v6x and v7.x.
2D SCREEN ON UNITS
WITH SOFTWARE
VERSIONS UP TO
VERSION v3.x.
To Next Page
Loading...
