GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 5 - Components and Functions (Theory) 5 - 91
5-4-6-4 BEP2 Description
NOTE: Specifications mentioned about the Back-End Processor (BEP2) is minimum requirements. The
actual hardware could exceed these specifications as technology advances.
5-4-6-4-1 The EMC Enclosure house
• A Power Supply with UPS battery backup,
• An Intel Motherboard with 768 Mbytes of RAM and a single 2.0 GHz P4 processor w/ 400 MHz FSB.
• Six (6x) USB Ports
• One (1x) Serial Port (COM1 used for modem (option) connection)
• USB to Serial adapter cable (USB #3 to II/O B7) for External I/O serial output
• AGP Video output from the motherboard (AGP Card Slot is empty)
• LAN output from the motherboard
5-4-6-4-2 Use of PCI slots on Motherboard
1.) Blank
2.) SCSI Card for MO Drive (Optional)
3.) Blank
4.) PC2IP Card. PCI Bus interface for the Front-End Processor
5.) Blank
5-4-6-4-3 AGP Video Card - SVGA Video to the PCVIC Card
• Analog output complies with the SVGA specification.
• Resolution (on monitor) is 800x600.
• Support for 32 bit True Color
• Minimum of 8 Mbytes of high speed Video RAM, expandable to at least 16 Mbytes.
• 128-bit internal memory interface.
• Hardware supported asynchronous bit block transfer (80 Mpixels/sec.).
5-4-6-4-4 PC2IO Board
This board does not plug into any slot but is mounted to the inside of the BEP chassis.
- Power and Internal PCI control signals
To Next Page
Loading...
