GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
5 - 90 Section 5-4 - Back-End Processor (BEP)
5-4-6-3 BEP2.2 Description
NOTE: Specifications mentioned about the Back-End Processor (BEP2.2) is minimum requirements.
The actual hardware could exceed these specifications as technology advances.
5-4-6-3-1 The EMC Enclosure house
• A Power Supply with UPS battery backup
• An Intel Motherboard with 768 Mbytes of RAM and a single 2.0 GHz P4 processor w/ 400 MHz FSB.
• Six (6x) USB Ports
• One (1x) Serial Port (COM1 used for modem (option) connection)
• AGP Video output from the motherboard (AGP Card Slot empty)
• Video Frame Grabber Card (Vivid 7 with FEP2)
• LAN output from the motherboard
5-4-6-3-2 Use of PCI slots on Motherboard
1.) SCSI Card for MO Drive (Optional)
2.) Blank
3.) Falcon Frame Grabber Card
4.) UPS Control (Not connected directly to MBD)
5.) PC2IP2 Card. PCI Bus interface for the Front-End Processor
6.) Blank
5-4-6-3-3 AGP Video - SVGA Video to the PCVIC Card
• Analog output complies with the SVGA specification.
• Resolution (on monitor) is 800x600.
• Support for 32 bit True Color
• Minimum of 8 Mbytes of high speed Video RAM, expandable to at least 16 Mbytes.
• 128-bit internal memory interface.
• Hardware supported asynchronous bit block transfer (80 Mpixels/sec.).
5-4-6-3-4 PC2IO Board
This board does not plug into any slot but is mounted to the inside of the BEP chassis.
- Power and Internal PCI control signals.
To Next Page
Loading...
