GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8 - 41
8-8-6-1 Move Images From the Local Hard Drive to MO disks. (cont’d)
7.) Press Backup Now.
- The system is checking that the MO disk is inserted. If not, a dialogue window is displayed
prompting the user to insert a MO disk. Select OK to resume backup.
- The system is checking that the MO disk is formatted. If not, a dialogue window is displayed
prompting the user to format the disk.
- The system is checking the available space on MO disk for the patient archive. If there is not
sufficient free space a dialogue window is displayed. Select OK, the media is ejected and
insert a new formatted MO disk.
A progress dialogue is displayed showing the current operation being performed.
If the amount of data exceeds the capacity of the MO disk, the user is prompted to insert a new
(formatted) MO disk. At the end of the process, a status for each item is displayed in the Result column.
If errors occur during backup, a list of the patient records/ examinations that could not be backed up is
displayed.
8-8-6-2 Backup of Patient Archive and System Configurations to MO Disks
The backup function is used to make a backup of the Patient Archive and the System Configurations.
1.) Format the MO disks you’re going to use for the backup, see 4-2-7 "Formatting Removable Media
- Software Version v3.x and above" on page 4-17.
2.) Insert the dedicated and formatted MO disk into the MO drive.
3.) Press CONFIG
(F2) and log on as adm, see 4-2-4 "Log On to the System as ‘ADM’" on page 4-12.
4.) Select the Admin screen.
5.) Select Patient Archive and System Configurations.
6.) Select the MO disk as destination.
CAUTION
Use a blank dedicated MO disk when doing backup. The backup will OVERWRITE the existing
data on the MO disk.
Figure 8-36 The Admin screen
To Next Page
Loading...
