GE Vivid 7 - Page 643

GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8 - 55
8-9-3 Customer Provided Prerequisite
• Formatted and labelled MO Disks for Images storage
• Formatted and labelled MO Disk for Patient Archive and User Defined Settings.
8-9-4 Tools Provided With Unit or After a Software Upgrade
8-9-4-1 Units with BT’02 Software
NOTE: Units with software version v2.3.0 or below and all version v1.x should be upgraded to software
version v2.3.1 as described in FMI 76037.
8-9-5 Preparations
1.) Switch ON the Mains Power Circuit Breaker and power up the unit, see 4-2-2 "Power ON/ Boot UP"
on page 4-3.
2.) Continue with 8-9-6 "Prepare MO Disks for Image Storage - Software Version v2.x" on page 8-56.
Table 8-14 CDs with BT’02 Software, Version v2.x
ITEM TITLE PART NUMBER DESCRIPTION
1
V7 SYSTEM SW CD, BEP1
FC200563
or
FC200165
FC200563_02 is system software version 1.5.1 (for BEP1)
FC200165_05 is system software version 1.3.3 (for BEP1)
V7 SYSTEM SW CD, BEP2.0
FC200564
or
FC200265
FC200564_02 is system software version 1.5.1 (for BEP2)
FC200265_04 is system software version 1.3.3 (for BEP2)
V7 SYSTEM SW CD, BEP4
as BEP2 (and BEP1) replacement
FC200825
USED for BEP4 as BEP2 (and BEP1) replacement
FC200824_01 is system software version 1.5.x
2
VIVID 7 & ECHOPAC PC APPL. SW FC200566
APPLICATION SOFTWARE,
COMMON TO Vivid 7 AND ECHOPAC PC
FC200566_03 IS APPLICATION SOFTWARE VERSION v2.4.2
VIVID 7 & ECHOPAC PC APPL. SW FC200220
Application software, common to Vivid 7 and EchoPAC PC
FC200220-14 is application sw. 2.3.5