GE Vivid 7 - Page 746

GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
9 - 50 Section 9-19 - Back-End Processor
6
PATIENT IO MODULE FC200685
WITH USB-1.1 INTERFACE. INTRODUCED FOR
BEP3.2
1 Y
PATIENT IO MODULE FC200805
WITH USB-2.0 INTERFACE. INTRODUCED FOR
BEP4.2
1 Y
7 FAN FOR BACK END PROCESSOR 2404028-11 For BEP3.x and BEP4.x 1 Y
8
PC2IP MODULE FC200617 1 Y
PC2IP2B FC200656 Communication between BEP and FEP2 (PC2IP) 1 Y
PC2IP3
FC200755
Communication between BEP and FEP2 (PC2IP)
This card will be phased in when PC2IP2B becomes
obsolete
1 Y
FD200033
Communication between BEP and FEP2 (PC2IP)
This card will be phased in when FC200755 becomes
obsolete
9 DGVIC-DGIO TRAY, COMPLETE FC200958
Replaces FC200676
1Y
10 DVI Loopback Cable 2354056 1 Y
11 FILTER ASSEMBLY FOR BEP VIVID7 FC200631 1 Y
12 BIOS Blaster FC200832 1 Y
13
System Software (Base Image) FC200824 Vivid 7 System sw v.2.x.x for BEP4 1 Y
System Software (Base Image) FD200078 Vivid 7 System sw v.3.x.x for BEP4 1 Y
14
HARD DISK 80GB SATA
BEP4 HDD FRU
066E0523
80 GIGABYTES SATA HARD DISK DRIVE FOR BEP4.
MOUNTING HARDWARE INCLUDED.
1Y
HARD DISK 160GB SATA
BEP4 HDD FRU
2404028-1
160 GIGABYTES SATA HARD DISK DRIVE FOR BEP4.
MOUNTING HARDWARE INCLUDED.
1Y
BEP CMOS BATTERY 2404028-7 1 Y
FALCON FRAME GRABBER PCI 066E0333 Used in units with FEP2 1 Y
PATIENT IO BT06 FC200805
WITH USB-2.0 INTERFACE. INTRODUCED FOR BT’06,
but will be phased into production when FC200685 be-
comes obsolete.
1 Y
Table 9-36 BEP4.2 FRU Parts (cont’d) sheet 2 of 2
ITEM PART NAME
PART
NUMBER
DESCRIPTION QTY FRU