Cinterion
®
EHS6 AT Command Set
7.20 AT+CECALL
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 159 of 513
7.20 AT+CECALL Initiate eCall
The AT+CECALL write command can be used to trigger an eCall to the network. You can either make a test call,
a reconfiguration call, a manually initiated eCall or an automatically initiated eCall.
To get detailed information on all eCall states you can use dedicated indicators enabled with AT^SIND: ecallda,
ecallco, ecaller. If voiceprompts are involved it is recommended to enable the AT^SIND indicators related to
"voiceprompt".
Syntax
Parameter Description
0
(P)
Test eCall (originate voice call)
1 Reconfiguration eCall
2 Manually initiated eCall
3 Automatically initiated eCall
99 Stop any ongoing eCall, and stop all timers related to eCall.
In eCall-only mode, AT+CECALL=99 forces the ME to deregister from the net-
work (unless already done automatically).
After successful execution of AT+CECALL=99, the eCall task is back to initial
state like after a powerup of the ME.
String of dialing digits. Phone number of PSAP test server. If parameter is set, this number will be used for
<type_of_ecall>= 0 (Test eCall). Number on SIM will be ignored.
Test Command
AT+CECALL=?
Response(s)
+CECALL: (list of supported <type_of_ecall>s)
OK
Read Command
AT+CECALL?
Response(s)
+CECALL: <type_of_ecall>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CECALL=<type_of_ecall>[, <ecall_nr>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN Last
- - -
<type_of_ecall>
(num)
<ecall_nr>
(str)
To Next Page
Loading...
Need help?
General
