Cinterion
®
EHS6 AT Command Set
10.1 AT^SICS
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 228 of 513
10.1 AT^SICS Internet Connection Setup Profile
AT^SICS serves to create and edit Internet connection profiles. A connection profile can be assigned to one or
more service profiles defined with AT^SISS, and thus, determines which type of connection is to be established
when opening a service profile with AT^SISO.
The AT^SICS read command requests the current settings of all Internet connection profiles.
The AT^SICS write command specifies all parameters of a connection profile identified by <conProfileId>.
To add or change the settings the write command needs to be executed for each single <conParmTag>. All pro-
file parameters set with AT^SICS are volatile. To save profile settings in non-volatile memory please refer to
AT^SIPS.
EHS6 is designed to use PAP authentication (Password Authentication Protocol) when parameters "user" and
"passwd" are given within the connection profile. If credentials are omitted, no authentication is performed.
The list below shows which <conParmTag> parameters are mandatory (= m) or optional (= o).
Table 10.1: Applicability of AT^SICS <conParmTag> values
Syntax
<conParmTag> <conParmValue-conType> GPRS0
"conType" m
"user" o
"passwd" o
"apn" m
"inactTO" o
"dns1" o
Test Command
AT^SICS=?
Response(s)
OK
Read Command
AT^SICS?
Response(s)
^SICS: <conProfileId>, <conParmTag>, <conParmValue>
[^SICS: ...]
OK
Write Command
AT^SICS=<conProfileId>, <conParmTag>, <conParmValue>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN Last
- + -
To Next Page
Loading...
Need help?
General
