Cinterion
®
EHS6 AT Command Set
2.5 ATV
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 36 of 513
2.5 ATV Result code format mode
This command determines the contents of header and trailer transmitted with AT command result codes and
information responses. Possible responses are described in Section 2.5.1, Verbose and numeric result codes.
Syntax
Parameter Description
[0] Information response: <text><CR><LF>
Short result code format: <numeric code><CR>
1
(&F)(D)
Information response: <CR><LF><text><CR><LF>
Long result code format: <CR><LF><verbose code><CR><LF>
2.5.1 Verbose and numeric result codes
Exec Command
ATV[<value>]
Response(s)
OK
ERROR
PIN Last Reference(s)
- + - ITU-T V.250 [16]
<value>
(num)(&V)(&W)
Verbose format Numeric format Meaning
OK 0 command executed, no errors
CONNECT 1 link established
RING 2 ring detected
NO CARRIER 3 link not established or disconnected
ERROR 4 invalid command or command line too long
NO DIALTONE 6 no dial tone, dialling impossible, wrong mode
BUSY 7 remote station busy
NO ANSWER 8 no answer
CONNECT 2400/RLP 10 link with 2400 bps
CONNECT 4800/RLP 11 link with 4800 bps
CONNECT 9600/RLP 12 link with 9600 bps
To Next Page
Loading...
Need help?
General
