Gemalto Cinterion EHS6 - 7.15 AT+CRLP Configure RLP Parameters for Outgoing Non-Transparent Data Calls

Cinterion
®
EHS6 AT Command Set 
7.15 AT+CRLP
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 151 of 513
7.15 AT+CRLP Configure RLP Parameters for Outgoing Non-Trans-
parent Data Calls
The AT+CRLP write command sets radio link protocol (RLP) parameters used when non-transparent data calls
are originated. The read command returns the current settings for the supported RLP version 0. 
Syntax

Parameter Description
Interworking window size (IWF to MS)
0...61
(&F)
Mobile window size (MS to IWF)
0...61
(&F)
Acknowledgement timer (T1 in 10 ms units)
48...[78]
(&F)
...255
Re-transmission attempts N2
1...6
(&F)
...255
Test Command
AT+CRLP=?
Response(s)
+CRLP: (list of supported<iws>s), (list of supported<mws>s), (list of supported<T1>s), (list of
supported<N2>s)
OK
Read Command
AT+CRLP?
Response(s)
+CRLP: <iws>, <mws>, <T1>, <N2>
OK
Write Command
AT+CRLP=[<iws>[, <mws>[, <T1>[, <N2>]]]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN  Last Reference(s)
- + - 3GPP TS 27.007 [45]
<iws>
(num)(&V)(&W)
<mws>
(num)(&V)(&W)
<T1>
(num)(&V)(&W)
<N2>
(num)(&V)(&W)