Gemalto Cinterion EHS6 - 7.24 ATS10 Set disconnect delay after indicating the absence of data carrier

Cinterion
®
EHS6 AT Command Set 
7.24 ATS10
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 164 of 513
7.24 ATS10 Set disconnect delay after indicating the absence of data
carrier
ATS10 is implemented for compatibility reasons only, and has no effect. 
Syntax

Parameter Description
001...002
(&F)
...254 Number of tenths of seconds to wait before disconnecting after ME has indi-
cated the absence of received line signal


Notes
•Command ATS10 is dummy, and has no effect on module behavior.
• Read command will return value written by user or default value n=2.
• Write command will return OK or ERROR. OK - when parameter <n> is in range, ERROR otherwise.
• Despite OK returned in case of any parameter from range, no changes will be made.
• Parameter is volatile.
Read Command
ATS10?
Response(s)
<n>
OK
Write Command
ATS10=<n>
Response(s)
OK
ERROR
PIN  Last Reference(s)
- + - ITU-T V.250 [16]
<n>
(num)(&V)(&W)