Cinterion
®
EHS6 AT Command Set
2.7 ATZ
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 38 of 513
2.7 ATZ Restore AT Command Settings from User Defined Profile
First ATZ resets the AT command settings to their factory default values, similar to AT&F. Afterwards the AT com-
mand settings are restored from a user defined profile in non-volatile memory of EHS6, if one was stored with
AT&W before. Any additional AT command on the same command line may be ignored. A delay of 300 ms is
required before next AT command can be sent.
Syntax
Parameter Description
[0] User Profile Number
Exec Command
ATZ[<value>]
Response(s)
OK
PIN Last Reference(s)
- + - V.250
<value>
(num)
To Next Page
Loading...
