Gemalto Cinterion EHS6 User Manual

Cinterion
®
EHS6 AT Command Set 
10.3 AT^SIPS
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 234 of 513
10.3 AT^SIPS Internet Profile Storage
AT^SIPS saves and loads the settings of the Internet connection and service profiles in the non-volatile memory.
AT^SIPS can also be used to reset the settings to their default values without saving. 
Syntax

Parameter Description
Internet profile storage type parameter.
“connection“ Handle AT^SICS parameter set.
“service“ Handle AT^SISS parameter set.
“all“ Handle AT^SICS parameters AT^SISS parameters listed above.
Internet profile storage action parameter
“reset“ Reset current profile(s) for given <type> to default settings without saving. 
If <ProfileId> is given only specific profile will be reset. 
Only the connections which are in "Down" status and the services which are in
"Allocated" status could be affected.
“save“ Stores current profile(s) for given <type>.
If <ProfileId> is given only specific profile will be stored.
“load“ Loads current profile(s) for given <type>.
If <ProfileId> is given only specific profile will be loaded.
Internet connection or service profile storage identifier
0...9 In case of connection profile, max = 5, please see <conProfileId>. 
In case of a service profile, max = 9, please see <srvProfileId>. 

If parameter is omitted, AT^SIPS applies to all possible profile identifiers of
used <type>.
Test Command
AT^SIPS=?
Response(s)
^SIPS:(list of supported <type>s), (list of supported <action>s), (list of supported <ProfileId>s)
OK
Write Command
AT^SIPS=<type>, <action>[, <ProfileId>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN  Last
- + -
<type>
(str)
<action>
(str)
<ProfileId>
(num)

Gemalto Cinterion EHS6 Specifications

General

Brand	Gemalto
Model	Cinterion EHS6
Category	Control Unit
Language	English