Gemalto Cinterion EHS6 User Manual

Cinterion
®
EHS6 AT Command Set 
8.7 AT+CPOL
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 175 of 513
8.7 AT+CPOL Preferred Operator List
AT+CPOL read command queries the list of the preferred operators. 
AT+CPOL write command allows to edit the list of the preferred operators. 
The response of AT+CPOL read command also depends on the setting of AT+CPLS. 
If <index> is given but <operator> is left out, the entry is deleted. 
Syntax

Parameter Description
The order number of the operator in the SIM preferred operator list.
0 Long alphanumeric format <operator>
1 Short alphanumeric format <operator>
2 Numeric format <operator>
The operator in the format specified in <format>.
Test Command
AT+CPOL=?
Response(s)
+CPOL:(list of supported <index>s), (list of supported <format>s)
OK
ERROR
+CME ERROR: <err>
Read Command
AT+CPOL?
Response(s)
+CPOL: <index>, <format>, <operator>[, <gsm>, <gsm_compact>, <utran>]
+CPOL: ...
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CPOL=[<index>][, <format>[[, <operator>][, <gsm>, <gsm_compact>, <utran>]]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN  Last Reference(s)
+ + - 3GPP TS 27.007 [45]
<index>
(num)
<format>
(num)
<operator>
(str)

Gemalto Cinterion EHS6 Specifications

General

Brand	Gemalto
Model	Cinterion EHS6
Category	Control Unit
Language	English