Gemalto Cinterion EHS6 - 9.5 AT+CCFC Call forwarding number and conditions control

Cinterion
®
EHS6 AT Command Set 
9.5 AT+CCFC
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 203 of 513
9.5 AT+CCFC Call forwarding number and conditions control
AT+CCFC controls the call forwarding supplementary service. Registration, erasure, activation, deactivation and
status query are supported. 
Syntax

Parameter Description
Reason for call forwarding
0 Unconditional
1 Mobile busy
2 No reply
3 Not reachable
4 All call forwarding (includes reasons 0, 1, 2 and 3)
5 all conditional call forwarding (includes reasons 1, 2 and 3)
Network operation to be performed for Supplementary service "call forwarding"
0 Disable call forwarding (disable service)
1 Enable call forwarding (enable service)
2 Query status of call forwarding (query service status)
Test Command
AT+CCFC=?
Response(s)
+CCFC:(list/range of supported <reason>s)
OK
Write Command
AT+CCFC=<reason>, <mode>[, <number>[, <type>[, <class>[, <time>]]]]
Response(s)
If <mode> is not equal 2 and command successful:
OK
If <mode>= 2, <reason> is not equal 2 and command successful:
+CCFC: <status>, <class>[, <number>, <type>]
OK
If <mode>= 2, <reason>= 2 and command successful:
+CCFC: <status>, <class>[, <number>, <type>[, <subaddress>, <satype>[, <time>]]]
OK
If error is related to ME functionality
ERROR
+CME ERROR: <err>
PIN  Last Reference(s)
+ ± - 3GPP TS 27.007 [45], 
3GPP TS 22.004 [25], 
3GPP TS 22.082 [30], 
3GPP TS 24.082
<reason>
(num)
<mode>
(num)