Gemalto Cinterion EHS6 - 14.3 AT+STKTR USAT Terminal Response Commands

Cinterion
®
EHS6 AT Command Set 
14.3 AT+STKTR
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 366 of 513
14.3 AT+STKTR USAT Terminal Response Commands
Each AT+STKTR write command allows entering the response to a USAT proactive command which was dis-
played by the URC +STKPRO.

The AT+STKTR test command returns the list or proactive commands (see <ProactCmd> of AT+STKPRO. 

Note: Value 0 in some of the commands specified below stands for parameter "last command" which is obsolete,
but not removed so far.
For the general <Result>s 32, 33, 38, 52, 53, 55, 57 and 58, it is mandatory for the ME to provide a specific
cause value by using the <AddResult> parameter (additional information). For others additional information will
be ignored. 
Syntax
Test Command
AT+STKTR=?
Response(s)
+STKTR:(list of supported <ProactCmd>s)
OK
Write Command
Refresh
AT+STKTR=01,<Result>[, <AddResult>]
Response(s)
OK
ERROR
+CME ERROR: <err>
Write Command
Set up event list
AT+STKTR=05,<Result>
Response(s)
OK
ERROR
+CME ERROR: <err>
Write Command
Set up call
AT+STKTR=16,<Result>[, <AddResult>]
Response(s)
OK
ERROR
+CME ERROR: <err>
Write Command
Send SS
AT+STKTR=17,<Result>[, <AddResult>]
Response(s)
OK
ERROR
+CME ERROR: <err>