Gemalto Cinterion EHS6 - 7.7 ATH Disconnect existing connection

Cinterion
®
EHS6 AT Command Set 
7.7 ATH
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 142 of 513
7.7 ATH Disconnect existing connection
ATH releases all active calls and held calls, but not waiting calls. 
Syntax

Parameter Description
[0] Disconnect from command line and terminate call


Note
• ATH terminates every circuit switched call (voice, data), even if it is issued via another interface. This behavior
is in accordance with ITU-T V.250; (07/97, "Hook control": "ATH is terminating any call in progress.").
Exec Command
ATH[<n>]
Response(s)
OK
PIN  Last Reference(s)
- - - ITU-T V.250 [16]
<n>
(num)