Cinterion
®
EHS6 AT Command Set
9.11 AT+CNAP
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 216 of 513
9.11 AT+CNAP Calling Name Presentation
AT+CNAP refers to the supplementary service CNAP (Calling Name Presentation) that enables a called sub-
scriber to get a calling name indication (CNI) of the calling party when receiving a mobile terminated call.
The AT+CNAP write command enables or disables the presentation of CNI at the TE. It has no effect on the exe-
cution of the supplementary service CNAP in the network.
The AT+CNAP read command gives the status of <n>, and also triggers an interrogation of the provision status
of the CNAP service according to 3GPP TS 22.096 (given in <m>). If no SIM card is available or the SIM-PIN is
not entered, the command response is "ERROR".
Syntax
Unsolicited Result Code
+CNAP: <name>[, <CNI validity>]
When CNAP is enabled at the TE (and is permitted by the calling subscriber), this URC is delivered after every
"RING" or "+CRING" URC when a mobile terminated call occurs.
Parameter Description
[0]
(&F)
Suppress unsolicited result codes
1 Display unsolicited result codes
Parameter shows the subscriber CNAP service status in the network and may be:
0 CNAP not provisioned
1 CNAP provisioned
Test Command
AT+CNAP=?
Response(s)
+CNAP: (list of supported<n>s)
OK
Read Command
AT+CNAP?
Response(s)
+CNAP: <n>, <m>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CNAP=<n>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN Last Reference(s)
± - - 3GPP TS 27.007 [45]
<n>
(num)(&V)(&W)
<m>
(num)(&V)
To Next Page
Loading...
Need help?
General
