Cinterion
®
EHS6 AT Command Set
11.10 AT+CGEREP
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 303 of 513
11.10 AT+CGEREP GPRS event reporting
The AT+CGEREP write command enables or disables sending of unsolicited result codes, "+CGEV" from MT to
TE in the case of certain events occurring in the Packet Domain MT or the network.
Parameter <mode> controls the processing of unsolicited result codes specified within this command. <bfr>
controls the effect on buffered codes when <mode> 1 or 2 is entered. If a setting is not supported by the MT,
ERROR or +CME ERROR: is returned.
The AT+CGEREP read command returns the current <mode> and buffer settings.
The AT+CGEREP test command returns the modes and buffer settings supported by the MT as compound values.
Syntax
Unsolicited Result Codes
URC 1
+CGEV: NW DEACT <PDP_type>, <PDP_addr>, [<cid>]
The network has forced a context deactivation. The <cid> that was used to activate the context is provided
if known to the MT.
URC 2
+CGEV: ME DEACT <PDP_type>, <PDP_addr>, [<cid>]
The ME has forced a context deactivation. The <cid> that was used to activate the context is provided if
known to the MT.
URC 3
+CGEV: NW DETACH
The network has forced a PS detach. This implies that all active contexts have been deactivated. These are
not reported separately.
Test Command
AT+CGEREP=?
Response(s)
+CGEREP: (list of supported <mode>s), (list of supported <bfr>s)
OK
Read Command
AT+CGEREP?
Response(s)
+CGEREP: <mode>, <bfr>
OK
Write Command
AT+CGEREP=[<mode>[, <bfr>]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN Last Reference(s)
+ + - 3GPP TS 27.007 [45]
To Next Page
Loading...
Need help?
General
