Cinterion
®
EHS6 AT Command Set
8.13 AT^SMONP
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 189 of 513
8.13 AT^SMONP Monitoring Neighbour Cells
The AT^SMONP supplies information of active cells and all neighbour cells. The active cell information will be
delivered additively because an ME can be situated in Soft Handover or Softer Handover.
Syntax
Notes
• Due to the fact that not all necessary information of the neighbour cells can be decoded during a connection,
there are several constraints to be considered:
- Only neighbour cells that have already been visible in IDLE mode will be further updated, as long as they
are still included in the list.
- Though new neighbour cells can be added to the list (e.g. due to handover), their C1 and C2 parameters
cannot be displayed until the connection is released. In this case "-" is presented for C1 and C2.
• The neighbour cells have the same PLMN as the serving cell.
• Parameters for which no values are available are shown as "-".
8.13.1 AT^SMONP Responses
Responses of AT^SMONP execute command:
• In case of a GSM (2G) serving cell:
Test Command
AT^SMONP=?
Response(s)
OK
Exec Command
AT^SMONP
Response(s)
See: Section 8.13.1, AT^SMONP Responses
OK
Write Command
AT^SMONP=255
Response(s)
See: Section 8.13.2, AT^SMONP Enhanced Responses
OK
ERROR
+CME ERROR: <err>
PIN Last
- - -
Syntax:
2G:
ARFCN
1
,rs
1
,dBm
1
,MCC
1
,MNC
1
,NCC
1
,BCC
1
,C1
1
,C2
1
,LAC
1
,cell
1
ARFCN
2
,rs
2
,dBm
2
,MCC
2
,MNC
2
,NCC
2
,BCC
2
,C1
2
,C2
2
,LAC
2
,cell
2
...
ARFCN
n
,rs
n
,dBm
n
,MCC
n
,MNC
n
,NCC
n
,BCC
n
,C1
n
,C2
n
,LAC
n
,cell
n
3G:
UARFCN
1
,PSC
1
,EC/n0
1
,RSCP
1
To Next Page
Loading...
Need help?
General
