Cinterion
®
EHS6 AT Command Set
11.4 AT+CGAUTO
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 288 of 513
11.4 AT+CGAUTO Automatic response to a network request for PDP
context activation
The AT+CGAUTO write command disables or enables an automatic positive response (auto-answer) to the receipt
of a Request PDP Context Activation message from the network. It also provides control over the use of the
V.250 basic commands ATS0, ATA and ATH for handling network requests for PDP context activation.
Syntax
Parameter Description
0 Disable automatic response for network requests for PDP context activation.
Packet Domanin network requests are manually accepted or rejected by the
AT+CGANS command.
1 Enable automatic response for network requests for PDP context activation.
Packet Domain requests are automatically accepted according to the descrip-
tion below.
2 Modem compatibility mode. Packet Domain only.
3
(P)
Modem compatibility mode. The automatic acceptance of both Packet Domain
and incoming circuit switched calls is controlled by the ATS0 command. Man-
ual control uses the ATA and ATH commands, respectively, to accept or reject
Packet Domain network requests or incoming circuit switched calls.
4 Turn on automatic negative response for Packet Domain only.
Notes
• When the AT+CGAUTO=0 command is received, the MT will not perform a PS detach if it is attached. Subse-
quently, when the MT announces a network request for PDP context activation by issuing the URC RING or
CRING, the TE may manually accept or reject the request by issuing the AT+CGANS command or may simply
ignore the network request.
Test Command
AT+CGAUTO=?
Response(s)
+CGAUTO: (list of supported <n>s)
OK
Read Command
AT+CGAUTO?
Response(s)
+CGAUTO: <n>
OK
Write Command
AT+CGAUTO=[<n>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN Last Reference(s)
+ - - 3GPP TS 27.007 [45]
<n>
(num)
To Next Page
Loading...
Need help?
General
