Cinterion
®
EHS6 AT Command Set
11.9 AT+CGEQREQ
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 299 of 513
11.9 AT+CGEQREQ Rel. 99 Quality of Service Profile (Requested)
The AT+CGEQREQ write command allows the TE to specify a Quality of Service Profile for the context identified
by the (local) context identification parameter <cid> which is used when the MT sends an Activate PDP Context
Request message to the network.
A special form of the write command, AT+CGEQREQ=<cid> causes the requested profile for context number
<cid> to become undefined.
The AT+CGEQREQ read command returns the current settings for each defined context.
The AT+CGEQREQ test command returns values supported as a compound value. Definitions of parameters can
be found in 3GPP TS 24.008 [40], subclause 10.5.5.6 and 3GPP TS 23.107 [38].
Syntax
Parameter Description
Parameter specifies a particular PDP context definition (see AT+CGDCONT parameter <cid>). The parameter
is used in other PDP context-related commands.
Test Command
AT+CGEQREQ=?
Response(s)
+CGEQREQ: <PDP_type>, (list of supported <Traffic class>s), (list of supported <Maximum bitrate
UL>s), (list of supported <Maximum bitrate DL>s), (list of supported <Guaranteed bitrate UL>s),
(list of supported <Guaranteed bitrate DL>s), (list of supported <Delivery order>s), (list of
supported <Maximum SDU size>s), (list of supported <SDU error ratio>s), (list of supported
<Residual bit error ratio>s), (list of supported <Delivery of erroneous SDUs>s), (list of
supported <Transfer delay>s), (list of supported <Traffic handling priority>s), <Source
Statistics Descriptor>, <Signaling Indication>
OK
Read Command
AT+CGEQREQ?
Response(s)
[+CGEQREQ: <cid>, <Traffic class>, <Maximum bitrate UL>, <Maximum bitrate DL>,
<Guaranteed bitrate UL>, <Guaranteed bitrate DL>, <Delivery order>, <Maximum SDU
size>, <SDU error ratio>, <Residual bit error ratio>, <Delivery of erroneous SDUs>,
<Transfer delay>, <Traffic handling priority>, <Source Statistics Descriptor>,
<Signaling Indication>]
[+CGEQREQ: ...]
Write Command
AT+CGEQREQ=[<cid>[, <Traffic class>[, <Maximum bitrate UL>[, <Maximum bitrate DL>[,
<Guaranteed bitrate UL>[, <Guaranteed bitrate DL>[, <Delivery order>[, <Maximum SDU
size>[, <SDU error ratio>[, <Residual bit error ratio>[, <Delivery of erroneous
SDUs>[, <Transfer delay>[, <Traffic handling priority>[, <Source Statistics
Descriptor>[, <Signaling Indication>]]]]]]]]]]]]]]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN Last Reference(s)
+ + - 3GPP TS 27.007 [45]
<cid>
(num)(NV)
To Next Page
Loading...
Need help?
General
