Gemalto Cinterion EHS6 - 2.3 AT&W Store AT Command Settings to User Defined Profile

Cinterion
®
EHS6 AT Command Set 
2.3 AT&W
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 34 of 513
2.3 AT&W Store AT Command Settings to User Defined Profile
AT&W stores the current AT command settings to a user defined profile in non-volatile memory of EHS6. The AT
command settings will automatically be restored from the user defined profile during power-up or if ATZ is used.
AT&F restores AT command factory default settings. Hence, until first use of AT&W, ATZ works as AT&F. 
A list of parameters stored to the user profile can be found at Section 21.4, AT Command Settings storable
with AT&W. 
Syntax

Parameter Description
[0] User Profile Number
Exec Command
AT&W[<value>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN  Last Reference(s)
- + - V.250
<value>
(num)