Gemalto Cinterion EHS6 User Manual

Cinterion
®
EHS6 AT Command Set 
11.14 AT+CGREG
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 312 of 513
11.14 AT+CGREG Packet Domain Network Registration Status
AT+CGREG write command enables presentation of URC "+CGREG: <stat>" when <n>=1 and ME's Packet
Domain network registration status changes, or URC "+CGREG: <stat>[, <lac>, <ci>][, <AcT>, <rac>]" when
<n>=2 and the current network cell changes. 
AT+CGREG read command queries the current URC presentation status and <stat> which shows whether the
network has currently indicated the registration of the ME. Location information elements <lac> and <ci> are
returned only if <n>=2 and ME is registered to the network. 
Syntax

Unsolicited Result Codes
URC 1
+CGREG: <stat>
Indicates a change in the ME's Packet Domain network registration status.
URC 2
+CGREG: <stat>[, <lac>, <ci>][, <AcT>, <rac>]
Indicates a change in the ME's Packet Domain network registration status or a change of the network cell
including location information.

Parameter Description
0
(P)
Disable network registration unsolicited result code
1 Enable network registration URC "+CGREG: <stat>"
2 Enable network registration URC "+CGREG: <stat>[, <lac>, <ci>][, <AcT>,
<rac>]"
Test Command
AT+CGREG=?
Response(s)
+CGREG: (list of supported <n>s)
OK
Read Command
AT+CGREG?
Response(s)
+CGREG: <n>, <stat>[, <lac>, <ci>][, <AcT>, <rac>]
OK
Write Command
AT+CGREG=[<n>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN  Last Reference(s)
+ + - 3GPP TS 27.007 [45]
<n>
(num)

Gemalto Cinterion EHS6 Specifications

General

Brand	Gemalto
Model	Cinterion EHS6
Category	Control Unit
Language	English