Gemalto Cinterion EHS6 - 8.11 AT^SGCOPS Operator Selection for GPRS-ONLY SIM Cards

Cinterion
®
EHS6 AT Command Set 
8.11 AT^SGCOPS
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 181 of 513
8.11 AT^SGCOPS Operator Selection for GPRS-ONLY SIM Cards
AT^SGCOPS has been designed for use with GPRS-ONLY SIM cards. Intended only for PS data connectivity
GPRS-ONLY SIM cards do not support registering to CS services. As a result, the standard command AT+COPS
is not fully usable for GPRS-ONLY SIM cards: Despite successful registration to PS domain services the
AT+COPS? read command returns "+COPS: 2" and the AT+COPS write command returns an error message
("+CME ERROR: SIM WRONG"). 

Therefore, for GPRS-ONLY SIM cards, please use AT^SGCOPS instead of AT+COPS. The command syntax of
the AT^SGCOPS read and write commands is identical with AT+COPS. See AT+COPS for parameter descriptions. 
Syntax
Read Command
AT^SGCOPS?
Response(s)
^SGCOPS:<mode>[, <format>[, <opName>][, <AcT>]]
OK
ERROR
+CME ERROR:<err>
Write Command
AT^SGCOPS=<mode>[, <format>[, <opName>][, <AcT>]]
Response(s)
OK
ERROR
+CME ERROR:<err>
PIN  Last
± - -