Gemalto Cinterion EHS6 - 2. Configuration Commands; 2.1 AT&F Reset AT Command Settings to Factory Default Values

Cinterion
®
EHS6 AT Command Set
2. Configuration Commands
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 31 of 513
2. Configuration Commands
The AT Commands described in this chapter allow the external application to determine the EHS6's behaviour
under various conditions.
2.1 AT&F Reset AT Command Settings to Factory Default Values
AT&F resets AT command settings to their factory default values. 

For a list of affected parameters refer to Section 21.5, Factory Default Settings Restorable with
AT&F. 
Syntax

Parameter Description
[0] Reset parameters in Section 21.5, Factory Default Settings Restor-
able with AT&F to their factory default values.
Exec Command
AT&F[<value>]
Response(s)
OK
PIN  Last Reference(s)
- + - V.250
<value>
(num)