Cinterion
®
EHS6 AT Command Set
16.11 AT^SRTC
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 405 of 513
16.11 AT^SRTC Ring tone configuration
The AT^SRTC read command returns the current <type> and current <volume>. The read command can be
used while test playback is off or on. In the latter case, see execute command for details.
The AT^SRTC execute command is intended only for testing. It starts to play a melody from the audio output cur-
rently selected with AT^SNFS. To deactivate test playback use AT^SRTC again.
During test playback, you can enter the write command to select another melody and adjust the volume. Also,
you can enter the read command to check the type and volume of the current ring tone, and to view the status
of playback (on / off).
The AT^SRTC write command chooses the type and volume of ring tones. The selected <type> and <volume>
are stored non-volatile. The only exception is <type>=0 which is not stored because it is intended only to quickly
stop the tone currently played. So <type>=0 only stops immediately the audible ring tone, but does not terminate
the RING URC. In this case the AT^SRTC write command returns only OK.
Syntax
Test Command
AT^SRTC=?
Response(s)
^SRTC:(list of supported) <type>s, (list of supported) <volume>s
OK
Read Command
AT^SRTC?
Response(s)
^SRTC: <type>, <volume>, <status>
OK
ERROR
+CME ERROR: <err>
Exec Command
AT^SRTC
Response(s)
OK
ERROR
+CME ERROR: <err>
Write Command
AT^SRTC=<type>[, <volume>]
Response(s)
^SRTC: <type>, <volume>
OK
ERROR
+CME ERROR: <err>
PIN Last
- + -
To Next Page
Loading...
Need help?
General
