Cinterion
®
EHS6 AT Command Set
16.11 AT^SRTC
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 406 of 513
Parameter Description
Type of ring tone. You have a choice of 8 different ring tones and melodies. All will be played from the audio
output selected with the AT^SNFS command. <type>=0 is only intended for stopping of current ringtone play-
back.
0 Stops the currently played tone immediately
1 Sequence 1
2 Sequence 2
3
(D)
Sequence 3
4 Sequence 4
5 Sequence 5
6 Sequence 6
7 Sequence 7
8 Sequence 8
Volume of ring tone, varies from low to high.
0
(D)
Mute
1 Very low
2Low
3Middle
4 High
Status of test ringing. Indicates whether or not a melody is currently being played back for testing.
0 Switched off
1 Switched on
Note
• Before first using ring tones note that the following settings apply:
We have chosen to let you decide your own preferences when you start using ring tones. Therefore, factory
setting is ^SRTC: 3,0,0 (ring tones are muted). To activate ring tones for the very first time, first enter the write
command and simply change the volume. After applying a firmware update the volume and type selected
before the firmware update will be preserved.
<type>
(num)
<volume>
(num)
<status>
(num)
To Next Page
Loading...
Need help?
General
