Gemalto Cinterion EHS6 - 7.11 ATO Switch from command mode to data mode; PPP online mode

Cinterion
®
EHS6 AT Command Set 
7.11 ATO
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 146 of 513
7.11 ATO Switch from command mode to data mode / PPP online
mode
ATO is the corresponding command to the +++ escape sequence: If the ME is in command mode during a data
connection ATO causes the ME to return to data mode. 
Syntax

Parameter Description
[0] Switch from command mode to data mode
Exec Command
ATO[<n>]
Response(s)
If connection is not successfully resumed:
NO CARRIER
or
TA returns to data mode from command mode
CONNECT <text>
Note: <text> output only if ATX parameter setting with value > 0.
PIN  Last Reference(s)
- - - ITU-T V.250 [16]
<n>
(num)