Cinterion
®
EHS6 AT Command Set
11.18 AT^SGAUTH
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 317 of 513
11.18 AT^SGAUTH Set Type of Authentication for PDP-IP Connections
The AT^SGAUTH write command allows to enter the type of authentication for the specified PDP context.
The AT^SGAUTH read command returns the current settings for each defined PDP context. If no PDP context is
defined the read command returns only OK result code.
Syntax
Parameter Description
Parameter specifies a particular PDP context definition (see AT+CGDCONT parameter <cid>).
Types of authentication to be used for the specified context.
[0] none
1 PAP
2 CHAP
Parameter specifies the password used for authentication.
Parameter is mandatory even if not needed by network. If no password is available the parameter shall be given
in the format "". This applies also when <auth_type> equals "0" (none).
Test Command
AT^SGAUTH=?
Response(s)
^SGAUTH:(range of supported<cid>s), (list of supported <auth_type>s), (max. string length of <user>),
(max. string length of <passwd>)
OK
Read Command
AT^SGAUTH?
Response(s)
^SGAUTH:<cid>, <auth_type>[, <user>]
^SGAUTH:<cid>, <auth_type>[, <user>]
...
OK
ERROR
+CME ERROR: <err>
Write Command
AT^SGAUTH=<cid>, <auth_type>, <user>, <passwd>
Response(s)
OK
+CME ERROR: <err>
PIN Last
- + -
<cid>
(num)(NV)
<auth_type>
(num)(NV)
<passwd>
(str)(NV)
To Next Page
Loading...
Need help?
General
