Gemalto Cinterion EHS6 - 12.10 AT+CMSS Send short messages from storage

Cinterion
®
EHS6 AT Command Set 
12.10 AT+CMSS
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 336 of 513
12.10 AT+CMSS Send short messages from storage
The write command sends message with location value <index> from message storage <mem2> to the network
(SMS-SUBMIT or SMS-COMMAND). If new recipient address <da> is given for SMS-SUBMIT, it shall be used
instead of the one stored with the message. Reference value <mr> is returned to the TE on successful message
delivery. Value can be used to identify message upon unsolicited delivery status report result code.
If the optional parameter <da> is given, the old status of the short message at <index> remains unchanged
(see <stat>). 
Syntax
Test Command
AT+CMSS=?
Response(s)
OK
Write Command
If text mode (AT+CMGF=1):
AT+CMSS=<index>[, <da>[, <toda>]]
Response(s)
+CMSS: <mr>[, <scts>]
OK
If sending fails
ERROR
+CMS ERROR: <err>
Write Command
If PDU mode (AT+CMGF=0):
AT+CMSS=<index>[, <da>[, <toda>]]
Response(s)
+CMSS: <mr>[, <ackpdu>]
OK
If sending fails
ERROR
+CMS ERROR: <err>
PIN  Last Reference(s)
+ - - 3GPP TS 27.005 [44]