Gemalto Cinterion EHS6 - Transparent TCP Listener: Autoanswering Incoming Remote Client

Cinterion
®
EHS6 AT Command Set 
10.15 Examples of how to Configure and Use Internet Service Profiles
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 269 of 513
Accept incoming connect request:
10.15.5 Transparent TCP Listener: Autoanswering Incoming Remote
Client
Configuring Transparent Socket Listener with Autoconnect enabled.
Starting Transparent TCP Listener
AT^SISC=2 Listener rejects connect request, where 2 is the
dynamically assigned service profile.
OK
^SIS: 1,1,2,"10.10.0.187:4098" URC indicates incoming connect request.
AT^SISO=2 Listener accepts connect request, where 2 is the
dynamically assigned service profile.
OK
^SISW: 2,1 URC indicates that data transmission is possible.
AT^SIST: 2 Open transparent access mode.
CONNECT Service enters transparent access mode.
Hello .... For further handling see examples below, e.g. Sec-
tion 10.15.10, Opening and Closing Transparent
TCP Service, Section 10.15.11, Transparent TCP
Client Receives Data While in AT Command Mode
AT^SISS=0,srvType,"Socket" Select Socket for service profile 0.
OK
AT^SISS=0,conId,0 Select connection profile 0.
OK
AT^SISS=0,"address","socktcp://
10.10.0.187:2000"
OK
AT^SISS=0,"tcpMR","3"
OK
AT^SISS=0,"tcpOT","5555"
OK
AT^SISS=1,"srvType","Socket" Select Socket for service profile 1
OK
AT^SISS=1,conId,0 Select connection profile 0.
OK
AT^SISS=1,"address","socktcp://lis-
tener:2000;etx=26;autoconnect=1"
"etx" configures Transparent mode. Autoconnect
enabled.
OK
AT^SISS=1,"tcpMR","3"
OK
AT^SISS=1,"tcpOT","5555"
OK
AT^SISO=1
OK
^SIS: 1,5 Listener ready.
AT^SISO=1,1
^SISO:
1,"Socket",3,3,0,0,"10.10.0.187:2000","0.0.
0.0:0"
OK
^SISW: 0,1
^SISW: 1,1