Cinterion
®
EHS6 AT Command Set
12.2 AT+CMGC
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 325 of 513
12.2 AT+CMGC Send SMS Command
Syntax
Notes
• After invoking the commands AT+CMGW, AT+CMGS or AT+CMGC it is necessary to wait for the prompt ">"
before entering text or PDU.
• In general but especially at baudrates below 19200 it is recommended to only use the command line termi-
nation character (ATS3) before starting text or PDU input. Use of line termination character followed by an
additional response formatting character (ATS4) may cause the problem that the latter will become part of the
input data.
Test Command
AT+CMGC=?
Response(s)
OK
Write Command
If text mode (see AT+CMGF=1)
AT+CMGC=<fo>, <ct>[, <pid>[, <mn>[, <da>[, <toda>]]]]<CR> Text can be entered <CTRL-Z>/<ESC>
Response(s)
+CMGC: <mr>[, <scts>]
If sending fails
ERROR
+CMS ERROR: <err>
Write Command
If PDU mode (see AT+CMGF=0)
AT+CMGC=<length><CR> PDU can be entered <CTRL-Z>/<ESC>
Response(s)
+CMGC: <mr>[, <ackpdu>]
OK
If sending fails
ERROR
+CMS ERROR: <err>
PIN Last Reference(s)
+ - - 3GPP TS 27.005 [44]
To Next Page
Loading...
Need help?
General
