Cinterion
®
EHS6 AT Command Set
19. Hardware related Commands
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 450 of 513
19. Hardware related Commands
All AT commands described in this chapter are related to the hardware interface of the EHS6. Further information
regarding this interface is available in the "EHS6 Hardware Interface Description" [2].
19.1 AT+CCLK Real Time Clock
The AT+CCLK write command sets the Real Time Clock in the ME.
The AT+CCLK read command shows the time.
Syntax
Parameter Description
Format is "yy/mm/dd,hh:mm:ss", where the characters indicate the two last digits of the year, followed by month,
day, hour, minutes, seconds; for example 6th of March 2013, 22:10:00 hours equals to "13/03/06,22:10:00"
Factory default is "04/01/01,00:00:00"
Note
• <time> is retained if the device enters the Power Down mode via AT^SMSO.
Test Command
AT+CCLK=?
Response(s)
OK
Read Command
AT+CCLK?
Response(s)
+CCLK: <time>
OK
Write Command
AT+CCLK=<time>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN Last Reference(s)
- + - 3GPP TS 27.007 [45]
<time>
(str)
To Next Page
Loading...
Need help?
General
