Gemalto Cinterion EHS6 User Manual

Cinterion
®
EHS6 AT Command Set 
15.6 AT+CSVM
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 390 of 513
15.6 AT+CSVM Set voice mail number
The number to the voice mail server is set by AT+CSVM command.
The parameters <number> and <type> can be left out if the parameter <mode> is set to 0. The read command
returns the status (enabled <mode>=1 or disabled <mode>=0), the currently selected voice mail <number> and
the <type>.
The test command returns supported <mode>s and <type>s. 
Syntax

Parameter Description
0 Disable the voice mail number
1 Enable the voice mail number
Phone number in format specified by <type>. Parameter must be present when setting (<mode>=1) the voice
mail number. Alphabetic characters are not permitted. The <number> may contain dialstring modifiers "*", "#",
"+" or "p".
Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).
If <type> is not specified the unknown <type>=129 is used. If <number> contains a leading "+" <type>=145
(international) is used.
Supported values are:
128 Restricted <number> includes unknown type and format.
Test Command
AT+CSVM=?
Response(s)
+CSVM: (list of supported <mode>s), (list of supported<type>s)
OK
ERROR
+CME ERROR: <err>
Read Command
AT+CSVM?
Response(s)
+CSVM: <mode>, <number>, <type>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CSVM=<mode>[, <number>[, <type>]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN  Last Reference(s)
+ + - 3GPP TS 27.007 [45]
<mode>
(num)
<number>
(str)(NV)
<type>
(num)

Gemalto Cinterion EHS6 Specifications

General

Brand	Gemalto
Model	Cinterion EHS6
Category	Control Unit
Language	English