Cinterion
®
EHS6 AT Command Set
15.5 AT+CPBF
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 389 of 513
255 Dialing string <number> is a command to control a Supplementary Service,
i.e. "*", "#" codes are contained. Network support of this type is optional.
129 Otherwise.
Text assigned to a phone number. The maximum length for this parameter is given with test command response
parameter <tlength>.
If using an ASCII terminal characters which are coded differently in ASCII and GSM have to be entered via
escape sequences as described in Section 1.7, Supported character sets.
String for finding the <text> in the active phonebook.
Maximum length of phone number for "normal" locations.
Maximum length of <text> assigned to the telephone number. The value indicated by the test command is
given in octets. If <text> is given as GSM characters each character corresponds to one octet. If the <text>
string is given in UCS2, the maximum number of characters depends on the coding scheme used for the alpha
field of the SIM according to 3GPP TS 11.11 [17], 3GPP TS 31.101 [18], 3GPP TS 31.102 [19], Annex B. In the
worst case the number of UCS2 characters is at least one less than half the number of GSM characters.
Example
<text>
(str)(+CSCS)
<findtext>
(str)(+CSCS)
<nlength>
(num)
<tlength>
(num)
AT+CPBF=?
First run the AT+CPBF test command to find out the
lengths of <nlength> and <tlength> in the active
phonebook.
+CPBF: 40,16
EHS6 returns the supported values, where 40 is the
maximum length of the phone number and 16 is the
maximum length of the associated text.
AT+CPBF="cha"
Then use the AT+CPBF write command to find any
<text> string in the phonebook.
+CPBF:1,"+999999",145,"Charlie"
To Next Page
Loading...
Need help?
General
