Gemalto Cinterion EHS6 - 10.7 AT^SISC Internet Service Close

Cinterion
®
EHS6 AT Command Set 
10.7 AT^SISC
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 249 of 513
10.7 AT^SISC Internet Service Close
The AT^SISC write command closes the TCP/IP connection to the remote peer which was opened with
AT^SISO. All resources are released, all status information parameters, e.g. <srvState>, <unackData>,
<ackData>, <rxCount> and <txCount> counters, are reset. Only the initial configuration settings are pre-
served. The service can be restarted any time, using the same configuration or a new one. 
Syntax

Parameter Description
0...9 <srvProfileId> specified with AT^SISS.
Test Command
AT^SISC=?
Response(s)
OK
Write Command
AT^SISC=<srvProfileId>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN  Last
± - -
<srvProfileId>
(num)