Gemalto Cinterion EHS6 - Page 246

Cinterion
®
EHS6 AT Command Set 
10.6 AT^SISO
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 246 of 513
• Transparent TCP Listener:
- Enter the AT^SISO command, e.g. AT^SISO=9.
- Wait for URC "^SIS" which indicates a client connect.
- If auto answering is not enabled enter AT^SIST to enter transparent access mode.
- Wait for "CONNECT" which indicates that transparent access mode is active.
- After communication has finished terminate the client connection using DTR toggle or AT^SISH after leav-
ing the transparent access mode.
- Close service with AT^SISC, e.g. AT^SISC=9. 
Syntax

Parameter Description
<srvProfileId> 0 ... 9 specified with AT^SISS.
The type of the internet service as specified by the AT^SISS parameter <srvParmValue-srvType>.
Internet service state. 
Please note, that the state of an Internet service may influence the state of the serial DCD line. For details see
description of value 2 for parameter <value> of command AT&C.
2 Allocated 
Service profile resources are allocated, i.e. at least the service type has been
set (parameter <srvParmTag>, value "srvType" of AT^SISS). The service is
not opened, but ready for configuration.
Test Command
AT^SISO=?
Response(s)
OK
Read Command
AT^SISO?
Response(s)
^SISO: <srvProfileId>, <srvType>[, <srvState>, <socketState>, <rxCount>, <txCount>,
<locAddr>, <remAddr>, <rejCounter>]
[^SISO: ...]
OK
Write Command
AT^SISO=<srvProfileId>[, <optParam>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN  Last
± - -
<srvProfileId>
(num)
<srvType>
(str)
<srvState>
(num)