Cinterion
®
EHS6 AT Command Set
10.4 AT^SISS
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 241 of 513
smHdr This parameter, if set, will be appended at the end of the email header section
(string).
Length: 0...254
Hence, it serves as a generic header field parameter which allows the user to
provide any email header field. It is the user's responsibility to provide correct
header fields!
String of max. 254 characters.
Example for multipart MIME messages:
"Content-Type: multipart/mixed".
smAuth SMTP authentication control flag (string).
If "smAuth" = "0" or "none": No authentication (for test environment only, not
applicable to real network)
If "smAuth" = "1" or "plain": Authentication with PLAIN authentification
If "smAuth" = "2" or "login": Authentication with LOGIN authentification
If "smAuth" = "3" or "cram": Authentication with CRAM authentification
smMsg SMTP message body. If no attachment is defined this is only the content of the
email.
Length: 0...254
tcpMR Parameter can be used to overwrite the global AT^SCFG parameter "Tcp/
MaxRetransmissions" <tcpMr> for a specific Internet Service connection pro-
file. If the parameter is not specified the value specified with AT^SCFG will be
used.
Supported values <srvParmValue> for this parameter are the same as
described for <tcpMr>.
Setting is not relevant for Internet Service "Socket" with type "UDP".
tcpOT Parameter can be used to overwrite the global AT^SCFG parameter "Tcp/Over-
allTimeout" <tcpOt> for a specific Internet Service connection profile. If the
parameter is not specified the value specified with AT^SCFG will be used.
Supported values <srvParmValue> for this parameter are the same as
described for <tcpOt>.
Setting is not relevant for Internet Service "Socket" with type "UDP".
Parameter value; type and supported content depend on related <srvParmTag>.
Supported Internet service type values in <srvParmValue> for <srvParmTag> value "srvType".
Before changing the "srvType" of an existing service profile be sure that the profile is closed. To verify the con-
nection state of the service profile enter the read command AT^SISI
. Only when <srvState>=2 is returned
for this specific service profile you can change its service type.
“Socket“ EHS6 acting as client or server (listener) for TCP or UDP. "etx" subparameter
in URL configures Transparent mode for Socket service.
If EHS6 is TCP listener at least two service profiles are required. The first
socket profile must be configured as listener. The second service profile will be
dynamically assigned when a socket connection request from a remote client
is incoming. For this purpose, one service profile must be left free (= not con-
figured with AT^SISS). An incoming socket connection request will be indi-
cated by the "^SIS" URC, with the next free <srvProfileId> shown inside
the URC as parameter <urcInfoId>. The connection request can be
accepted or rejected by using the commands AT^SISO or AT^SISC and the ID
retrieved from the "^SIS".
“Ftp“ EHS6 acting as FTP client.
“Http“ EHS6 acting as HTTP client.
<srvParmValue>
(str)(+CSCS)
<srvParmValue-srvType>
(str)
To Next Page
Loading...
Need help?
General
