Cinterion
®
EHS6 AT Command Set
7.17 AT^SXCALLSTAT
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 154 of 513
7.17 AT^SXCALLSTAT Set Reporting Call Status
AT^SXCALLSTAT enables / disables voice call status reporting using an unsolicited result code. The URC may
be repeated so that for each call one line is displayed.
Syntax
Unsolicited Result Code
Unsolicited Call Status information
^SXCALLSTAT: <n>, <stat>
URC "^SXCALLSTAT" displays the current call state. The state is displayed in the state it has at the time of dis-
play, not in the state it had when the signal was generated.
Parameter Description
[0] Presentation of URC "^SXCALLSTAT" disabled
1 Presentation of URC "^SXCALLSTAT" enabled
Call identification number
State of the call
0 Active
1Held
2 Dialing (MOC)
3 Alerting (MOC)
Test Command
AT^SXCALLSTAT=?
Response(s)
^SXCALLSTAT: (list of supported<n>s)
OK
Read Command
AT^SXCALLSTAT?
Response(s)
^SXCALLSTAT: <n>
OK
Write Command
AT^SXCALLSTAT=[<n>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN Last
+ - -
<n>
(num)
<idx>
(num)
<stat>
(num)
To Next Page
Loading...
Need help?
General
