Gemalto Cinterion EHS6 - 11.7 AT+CGCMOD PDP Context Modify

Cinterion
®
EHS6 AT Command Set 
11.7 AT+CGCMOD
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 294 of 513
11.7 AT+CGCMOD PDP Context Modify
The AT+CGCMOD write command can be used to modify the specified PDP context(s) with respect to QoS profiles
and TFTs. If no <cid>s are specified then all active contexts will be modified. 
If modification of a context fails, then AT+CEER may provide further informations about the reason. 

The AT+CGCMOD test command returns a list of <cid>s associated with active contexts which could be modified. 
Syntax

Parameter Description
Parameter specifies a particular PDP context definition (see AT+CGDCONT parameter <cid>).
Test Command
AT+CGCMOD=?
Response(s)
+CGCMOD: (list of <cid>s associated with active contexts)
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CGCMOD=[<cid>[, <cid>]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN  Last Reference(s)
+ - - 3GPP TS 27.007 [45]
<cid>
(num)