Gemalto Cinterion EHS6 - 11.11 AT+CGPADDR Show PDP address

Cinterion
®
EHS6 AT Command Set 
11.11 AT+CGPADDR
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 305 of 513
11.11 AT+CGPADDR Show PDP address
The AT+CGPADDR exec command returns a list of PDP addresses for all defined contexts. 
The AT+CGPADDR write command returns a list of PDP addresses for the specified context identifiers. If a context
is not defined, then no output line is generated for it. If no <cid> is specified, the addresses for all defined con-
texts are returned. 

The AT+CGPADDR test command returns a list of defined <cid>s. 
Syntax

Parameter Description
A numeric parameter which specifies a particular PDP context definition (see AT+CGDCONT command).
A string that identifies the MT in the address space applicable to the PDP. The address may be static or dynamic.
For a static address, it will be the one set by AT+CGDCONT when the context was defined. For a dynamic address
it will be the one assigned during the last PDP context activation that used the context definition referred to by
<cid>.
Test Command
AT+CGPADDR=?
Response(s)
[+CGPADDR: (list of defined <cid>s)]
OK
Exec Command
AT+CGPADDR
Response(s)
[+CGPADDR: <cid>, <PDP_address>]
[+CGPADDR: ...]
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CGPADDR=[<cid>[,<cid>]]
Response(s)
[+CGPADDR: <cid>, <PDP_address>]
[+CGPADDR: <cid>, <PDP_address>]
OK
ERROR
+CME ERROR: <err>
PIN  Last Reference(s)
+ + - 3GPP TS 27.007 [45]
<cid>
(num)
<PDP_address>
(str)